METOLIGHT LED-Tube-060-10-RAD-adj, 60 cm, 10 Watt, nature white, adjustable sensor

METOLIGHT LED-Tube RAD-adj, 60 cm, 10 Watt, 1000 lm, matted, nature white

LED Tube with adjustable sensor

Retrofit replacement for CFL-tube 60 cm - 18 Watt

This LED tube is an energy saver par excellance. Ideal for use in car parks, archives, underpasses and wherever only when necessary light is needed and this then to turn on automatically.
Unlike conventional sensor tubes you can set the time to switch back to sleep between 5 seconds and 1 hour, and the brightness in sleep mode between 0% and 40%. This tube saves up to 70% energy compared to conventional LED tubes up to 99% compared to permanently powered fluorescent tubes.
The MW-sensor according to the Doppler principle has a viewing distance of approximately 10 m. This LED tube can also be used in diffuser luminaires - the sensor switches even reliable.


The METOLIGHT LED tube RAD-adj is significantly brighter than conventional fluorescent tube 60 cm / 18 Watt - T8. The matted shell ensures glare-free light at light angle of approximately 120 ° -140 °. The optimum mounting height is below 4 m. With the locking and adjustable end caps the tube can also be used in luminaires with lateral socket slots. Rewiring of the lamp or even remove the existing ballasts is not necessary. The METOLIGHT RAD-adj works on all magnetic ballasts as well directly to 230V AC. It only needs to exchange the supplied LED-starter (item 101495).
However in tandem wiring the function must be checked before. Here it may be that the tube does not light up. An operation on emergency power systems with DC voltage 180 and 260 V DC between is possible.
Applications:
The LED tube light in color 3800-4500K - cold white is ideal for use in (deep) garage leasing, hall ways, storage rooms, archives, underpasses etc. The LED tube can be used in appropriately protected diffuser luminaires and outdoors and in cooling / freezing rooms. They can not be operated with dimmers or electronic ballasts.
Specials:
Epistar high efficiency SMD LEDs with 120 lm / W, CRI Ra> 80, 26 mm - T8 diameter, fixed G13. Special aluminum-core PCB for best heat dissipation and extremely long service life. Double insulated power supply with short circuit protection, stable aluminum cooling profile, extra lightweight, unbreakable construction, very störstrahlungsfest, no flicker by voltage fluctuations.
Easy installation:
Power off the luminaire - take off old fluorescent tube and starter - insert METOLIGHT LED starter - insert METOLIGHT LED tube RAD-adj - turn on power - done.
Sensor settings:
using a screwdriver to adjust sleep brightness from 0% (off) and 40% as well as the time delay between about 5 seconds and 1 hour according to your needs.
Single test at ASMETEC:
Each LED tube is individually checked in ASMETEC light laboratory to function and compliance with technical data. In addition, each LED tube passes through an insulation resistance test. The testing of the photometric data, ISO lines, EMC, switching cycles tests, etc. are carried out batchwise. Customers receive on request the relevant testing protocols.
Notes:
Also available in other colors of light: 3000, 6000K
Warranty:
This LED tube we give up to 5 years warranty (see warranty conditions)